There are two main types of well pumps: jet pumps and submersible pumps. Jet pumps are less expensive and easier to install, but they are not as durable or efficient as submersible pumps. Submersible pumps are more expensive and more difficult to install, but they are more durable and efficient, especially for deep wells.

The size of the well pump you need will depend on the depth of your well, the flow rate you need, and the static water level in your well. You should consult with a qualified well pump installer to help you determine the right size pump for your needs.

The best place to install your jet pump is in a dry, well-ventilated area. It is important to install the pump away from any sources of heat or vibration. The pump should also be easily accessible for maintenance and repair.

The installation process for a well pump will vary depending on the type of pump you are installing and the depth of your well. It is important to follow the manufacturer’s instructions carefully. If you are not comfortable installing the pump yourself, you should hire a licensed pump installer in NH.

Priming a well pump is the process of filling the pump with water before you turn it on. This is necessary to prevent the pump from running dry and burning up. The priming process will also help to remove any air from the pump line.

The well pump should be connected to your plumbing system using pex or PVC pipe. The pipe should be sized properly to handle the flow rate of the pump. It is important to use all-threaded pipe fittings and to seal all joints with pipe sealant.

The well pump should be wired to a dedicated electrical circuit. The circuit should be properly sized to handle the amperage requirements of the pump. It is important to seek help from a licensed pump installer to wire the pump.

A pressure switch is a device that turns the well pump on and off based on the water pressure in the system. The pressure switch is typically set to turn the pump on when the pressure drops below a certain level and to turn the pump off when the pressure reaches a certain level.

A check valve is a device that prevents water from flowing back into the well when the pump is turned off. The check valve is typically installed on the discharge pipe of the pump.

It is important to maintain your well pump regularly to ensure that it operates properly and lasts a long time. You should inspect the pump regularly for leaks and damage. You should also lubricate the pump according to the manufacturer’s instructions. It is a good idea to have your well pump inspected and serviced by a qualified well pump installer once a year.